Fuser Installation

Models: 2100|2100m|2100se|2100n 2100xi|2100tn | 2200 | 2200d
2200dt | 2200dse | 2200dtn

NOTE: These instructions are simply a guide. First Choice assumes no responsibility or liability for any damages caused by user while working on there printer during this repair.

	Tools Required • # 2 phillips screwdriver
	Step 1 Begin by facing the rear of the printer and Identifying the fuser cover.
	Step 2 Remove the two screws, holding the cover plate on.
	Step 3 Gently remove the cover plate working it from top to bottom. Be careful not to damage this plate there are plastic sensors attached.
	Step 4 After the cover plate is off identify and remove the fuser screw located on the left. (See picture)
	Step 5 Remove fuser wiring as seen in picture there will be three connectors total.
	Step 6 Simply slide the fuser outward, your done. http://www.feedroller.com